THE timing and size of three deadly earthquakes that struck Italy in 2016 may have been pre-determined, according to new research led by North-East experts.

The study involving led by Durham University and coming of the second anniversary of the start of the earthquake sequence could improve future earthquake forecasts.

A joint British-Italian team of geologists and seismologists have shown that the clustering of the three quakes might have been caused by the arrangement of a cross-cutting network of underground faults.

The findings show that although all three earthquakes occurred on the same major fault, several smaller faults prevented a single massive earthquake from occurring instead and also acted as pathways for naturally occurring fluids that triggered later earthquakes.

The cluster of three earthquakes, termed a “seismic sequence” by seismologists, each had magnitudes greater than six and killed more than 300 people in Italy’s Apennine mountains between 24 August and 30 October 2016.

The study published in the journal Earth and Planetary Science Letters could have wider implications for the study of seismic hazards, enabling scientists to better understand potential earthquake sequences following a quake.

Dr Richard Walters, assistant professor in the department of earth sciences, Durham University, said: “These results address a long-standing mystery in earthquake science - why a major fault system sometimes fails in a single large earthquake that ruptures its entire length, versus failing in multiple smaller earthquakes drawn-out over months or years.

“Our results imply that even though we couldn’t have predicted when the earthquake sequence would start, once it got going, both the size and timing of the major earthquakes may have been pre-determined by the arrangement of faults at depth.

“This is all information we could hypothetically know before the event, and therefore, this could be a hugely important avenue for improving future earthquake forecasts.”

Dr Walters and the team used satellite data to estimate which part of the fault failed in each earthquake, and compared this pattern with the location and timing of thousands of tiny aftershocks throughout the seismic sequence.

They found that intersections of small faults with the main fault system separated each of the three largest earthquakes, strongly suggesting these intersections stop the growth of each earthquake and prevent the faults failing in a single large event.

But in addition, the scientists also found that after the first earthquake, thousands of aftershocks crept northwards along these same fault intersections at a rate of around 100 metres per day, in a manner consistent with naturally occurring water and gas being pumped along the faults by the first earthquake on 24 August, 2016.

The second earthquake, on the 26 October, occurred exactly when these fluids reached its location, therefore controlling the relative timing of failure.

Dr Walters added: “It was a big surprise that these relatively small faults were having such a huge influence over the whole sequence.

“They stop the first earthquake in its tracks, and then they channel the fluids that start the sequence up again months later. No-one’s ever seen this before.”

Co-author Dr Laura Gregory, in the School of Earth and Environment, at the University of Leeds, UK, said it was important to understand whether or not a fault fails in a seismic sequence, and that the team’s results were only made possible by combining a varied array of different datasets.

The research was partly supported by the UK’s Natural Environment Research Council, via an Urgency Grant, and the Centre for the Observation and Modelling of Earthquakes, Volcanoes and Tectonics (COMET).